repair

Hello all, I noticed this rot on my slide outs after my last camping trip: Pretty gnarly. The other ends are in similar condition, but this corner was the worst. The rot feels to propagate ~1ft back. Are these structural? Could I just remove it and replace it with a new piece? Has...

Hello everyone. I am new to RVing, and on my first "real" camping trip, I blew a tire on my way back home and want to get opinions on what to do with the damage. I guess I'm trying to figure out if it's repairable without insurance claim or not. Please see pictures. 2021 Salem

I have completely opened up the cab over on the driver's side. I will be replacing a piece of floor and then start on the hole. Question: would it be better to seal the cut luan foam and the panel together and then install it or install a piece at a time?

Latest THING to fall off, and I can't figure out WHERE it attaches to on the other end. ANY help would be appreciated. It's a flex hose attached directly to the front grille.

I have a 2007 Forest River Cherokee Lite 28' travel trailer that I have owned for 7 years. My wife and I have done a lot of upgrades to it to make it very comfortable for our needs. It has served us well, including an almost 9k mile road trip in 2019. Yesterday was our first trip this season and...

While prepping on our last night of camping for the next day's departure for home, I noticed one of the slide topper brackets had completely detached from the slide and was laying on top of the slide. Three screws were still in the bracket, held in place by the butyl tape backing, one was...

I just tried backing my 06 Beaver Monterey from soft ground onto hardtop (uneven ground) and got stuck, tried to accelerate through and RV stopped moving along with a loud grinding noise, Did I just fry the tranny, or is a drive shaft issue?

Hello all. 2020 Eagle HT 27.5 RLTS here. My vinyl floor is bubbling in three places. All three bubbles are roughly six inches wide and roughly 24 inches in length. I'm looking for suggestions for the type of glue to use, plus whether to inject or slice the flooring to re-glue. I hope you are...

I am the second owner of a 2019 Greyhawk 29MV. I have noticed that there is tape in the corners of the dinette where the back is attached to the sides with an aluminum angle piece. The tape completely covers the bracket. Question: Is it possible this tape is original from the factory or possibly...

I have on my CC fiver two windows on my slide and broke one of the bottom tilt-out vent windows, very little help from Cedar Creek and even less from Lippert,, all they want is to sell me a complete window,,,not! My question is,,, -Anyone out there replaced a lower bottom tilt-out glass before...

I'm looking for a replacement exterior trim piece for a 2016 Winnebago Vista LX. Lichtsinn indicates it's only available from Winnebago as a special order at $175. That's over my budget. It's a bit over 1.5". Pictures attached.

I have a 2022 Dynamax Isata 3 I looking for a door or assembly that holds the dump valve handles. Any suggestions to where I can buy

My newly purchased 2001 Safari has lower rock guards, what is aluminum panel inserted and riveted inside bend frame. The frame on my trailer crack in 2 places and the panel flex with air flow, scrubbing trailer skin, so it need to be repaired. I called dealer and seems the rockguard is standard...

Where can I find the paint specs for a 2024 Forester 3011DS Scarlet paint design?

Hello everyone, I bought a 2005 FWC Eagle last spring with the goal of fixing it up in mind, but I've had so much fun using it since then that I haven't really got around to working on it until now. The first thing I want to tackle is repainting/resealing the roof, as it seems like there are a...

This little gizmo fell out of the supply line to my faucet. It appears to be a check valve or back flow preventer as no water would run when I reinstalled it, apparently backwards. I could not see how to put it back in so left it out and every thing works beautifully. I can put it back in if...

Hi everyone - After having a few different campers over the years (cabover, pop-up camp trailer) this is our first endeavor into the travel trailer space and super excited about it. We picked up a 1989 Wilderness and the previous owner did a great job updating the inside, painting, new...

Good morning! I’m looking for some general help regarding a Sandpiper 3800RK that I’m looking at purchasing, and any input would be greatly appreciated. The unit has been written off for “flood” damage, however it’s very evident that no water made it into the main body. So my main concern is the...

Hey everybody! I noticed yesterday that the top windshield molding was starting to crack along the length of the windshield on my ‘24 Bounder 35GL. Went on the REV group parts website, entered all my info and it showed me all the parts pertaining to replacing the molding on the windshield...

I’m looking for detailed instructions on how to remove the instrument panel in a 2004 Winnebago Adventurer so it can be rebuilt. Thanks in advance.

Trying to find out what kind sealant Tiffin used on my 2020 Openroad. I'm asking about the sealant that's applied to the top edge of the drip rail that's attached to the roof radius. Apparently the drip rail wasn't cleaned of dust or dirt before application when coach was built and it's starting...

Hello everyone, I recently purchased a Roadtrek and it may have experienced some water damage. I am wanting to re-upholster the walls/AC ceiling. I can be handy but not sure were to even star. Any ideas and or suggestions in the Phoenix area?

I am needing to replace the slideout motor for my 2003 Timberlodge RLS. Dos anyone know where I can find one or is there another option that would fit as a replacement? Thanks

Has anyone that has an Outdoors RV dealt with broken stairs? On our way out of town, the pin on the stairs broke. Trying to decide if we should repair or buy new stairs.

Both are damaged, various issues like non functioning switches, hacked wiring (passenger seat), broken recline gearbox (driver's seat) and more. Currently in AZ (Tucson, Mesa), returning to WA. Hoping to find someone here or in OR or WA who has actual experience and ability to work on these as...