Accessing Bulbs in Small Roadtrek Swivel Lights

Thread Summary

Summarized on:
Original Member Title: How to access bulb in tiny RV lights
This AI-generated summary may contain inaccuracies. Please refer to the full thread for complete details.
A member asked how to access the bulb in the small 2 to 3 inch rotating lights over the bed in a 2011 Chevy Roadtrek 210 Versatile without breaking anything. Members said the lens and surrounding bezel come out together and are held by small tabs or pegs that can be hard to see.

Main viewpoints
  • Use a fine flat-blade screwdriver around the edge to gently open the gap, find the tabs, push them in slightly, and pry carefully.
  • The plastic tabs may be brittle from age and lamp...
More...

teslasmuse

Advanced Member
Joined
Apr 5, 2026
Posts
43
Location
Montana
I have two of these small, 2-3" rotatable lights over my bed in my 2011 Chevy Roadtrek 210 Versatile, does anyone know how to access the bulb? I don't want to break anything by yanking
 

Attachments

  • 20260417_130447.jpg
    20260417_130447.jpg
    147.7 KB · Views: 64
Last edited:
The lens and the bezel around it come out. That piece is held in by 2 or 3, I am not sure as it has been many years since I had ours apart, little tabs that are very hard to find.

Going around the edge with a fine blade small screw driver and prying the slot open a bit will allow you to find them. Take the fine blade and push tab in a bit and carefully pry up. As they get old and with the lamp heat the tabs can get very brittle so may break off.
 
i think the dealership will swap it out with a new one for me, since they put it in in October, but I will keep that in mind, thanks!
 
I didn't fight with the dealership about replacing the bulb again for free past 90 day warranty since they fixed my water leaks for free so I finally bought an ST.5 square tip to get the light out but I can't figure out how to access the bulb and I don't want to break anything, any ideas? The bulb appears to be under the white piece but it doesn't twist or seem like it will pop out. Do I need to pry it out? 🤔
 

Attachments

  • 17840618330022801752559693212024.jpg
    17840618330022801752559693212024.jpg
    141.3 KB · Views: 27
I got brave and slide a flat head under the white piece and twisted and it popped them apart, it was very corroded after just being changed in Nov so that's a little concerning but now the LED bulbs I bought don't fit through the hole, sigh. I wouldn't care except I sleep at that end and it's nice to have the less bright light available
 

Attachments

  • 20260714_163654.jpg
    20260714_163654.jpg
    58.6 KB · Views: 23
Try these. They are brighter and cooler.https://www.amazon.com/stores/DreamLighting/page/DA8E0F3E-B80B-4FAF-9107-8780A1F81E8A?lp_asin=B0192YQCQA&ref_=ast_bln&store_ref=bl_ast_dp_brandlogo_sto#:~:text=You%20might%20also-,like
 

New posts

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top